Displaycal tv calibration12/14/2023 Two ViewSonic VP2365LED monitors (LCD with LED backlight, but I don’t know if it’s white or RGB but I suspect it’s white).What settings Displa圜AL should I be using? What’s the procedure I should be following? The three colors separate before finally rejoining at 100%. RGB Gray Balance shows an equal drift starting at 87%. Looking at the Gamma chart, values at 80% start falling off and turn from green to yellow and red. This seems to be what I see, where the brighter grays get a color cast. There they jump to a delta of 3.06 and even 4.21. The summary listed everything as “not ok.” Looking at the overview, values are in the green until I get to #38-#40. Without knowing much about what I’m doing, I ran the Measurement Report. Wait an hour, and I get a color cast using the generated profile. Eventually I get the RGB colors to balance even if the brightness was below the target. Increasing brightness would only cause the already too high color value to increase.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |